We provide a measuring guide for each type of wardrobe, making it incredibly easy for you to take measurements. Built-in wardrobes are always fitted with a little space on all sides. This space (also called "shadow gap") is necessary to ensure the wardrobes can be properly installed. So, you would have to make a serious measuring mistake for your wardrobe not to fit. This means for you: If you can handle a standard folding ruler and pencil, not much can go wrong!

For cabinets:

Side slopes must not exceed an angle of 60 degrees. For side slopes over 60 degrees, we can alternatively produce a stepped version of the cabinet. The price would decrease slightly. The minimum depth for cabinets is 15 cm. We can manufacture cabinets with a maximum depth of 80 cm. If your cabinet needs to be deeper, we can offer you the option to configure two cabinets and place them in front of each other. The cabinet elements must not be narrower than 35 cm. There is no maximum width.

Drawers:

Drawers must have a minimum width of 34 cm and must not be wider than 100 cm. Internal drawers should not be wider than 80 cm.

Clothes lift:

To install a clothes lift, the cabinet element must be at least 79 cm wide (external measurement).

Doors:

Doors should be no wider than 60 cm, as they would otherwise be too heavy and would open too far into the room. If the element is over 60 cm wide, double doors can be fitted. If you prefer a single door and it cannot be fitted, increase the number of elements in configuration step 3. This way, the elements will be narrower, allowing a single door to be fitted.

Our standard hinges open to just over 90 degrees. However, we can also install hinges for you that have an opening angle of 170 degrees. These hinges cost only €8.00 without damping and €10.00 with damping per hinge. Please enter this special request in the comments field when placing your order."